Today, at the peak of the popularity of various dresseslengths and styles. But what if you want to keep pace with time and money on a new wardrobe is not? Try to make yourself - it will give you double the fun: you sew fashionable dress just for her figure, taking into account all its features, and will be proud to have made it yourself! In this article, we will tell you how to carve out a dress for example, a very simple style, from which you can then make a dress for all occasions.
1. First remove the measurements:
— Полуобхват шеи, груди, талии и бедер
— Длина спины и переда до талии
— Ширина спины
— Высота груди
— Центр груди
— Длина плеча
— Длина изделия
2. Add to the standards of allowances:
— 5 см по линии груди
— 1 см по линии талии
— 2 см по линии бедер
3. Take a piece of paper or tracing paper of sufficient size, which will build the pattern.
4. Build on the sheet on the left vertical line equal to the length of the dress. Right from her dress aside width by adding an allowance for the breast line.
5. Subsequent build made mainly in the resulting rectangle. Aside from the top of the back length to the waist - down and the width of the back - to the right, then mark the hip line. From the line indicating the width of the back, put the right width armhole.
6. In the upper right corner of the rectangle, which is counting, build cut back neck and shoulder cut. Down the line of the shoulder cut aside deep armholes, then draw a line cut armholes back and forehand.
7. Затем постройте срез горловины переда (полочки) и обозначьте на чертеже центр груди и высокую точку груди. Рядом с линией плечевого среза обозначьте нагрудную выточку. После этого определите линии бокового шва, раствора выточек по талии и ширины платья по линии бедер.
8. Now you can build a recess, and then find the line forehand waist, hip line, shelves bottom line, build the groove on the back and shelf. Pattern is ready.
How to carve out a skirt
Sometimes the skirt cuts out separately from the upper part of the dress and stitch the top to the bottom at the end. Here are a few tips on how to carve out a skirt alone.
— Вам понадобятся следующие мерки: полуобхват талии, бедер, расстояние от талии до пола спереди, сзади, от пола до нижнего края юбки и длина спины до талии.
— По линии талии припуск не берется, по лини бедер – 1 см.
An algorithm for constructing the pattern:
1. Construction start from the bottom. From the lower left corner set aside up length skirt from behind, we find the hip line that then find the width of the skirt, taking into account the allowance.
2. Then build long skirt front and side seam line. In it we find the length of the side skirts. We spend waist line connecting points on the length of the lines in the front, rear and side.
3. perform calculations recesses waist, find the position, length and depth of the front and rear recesses. We are building a lateral recess and make out the upper cut skirt.
We hope that the material in this article will help you in the home sewing.
So the dress is ready, now it's time tocook something delicious for the whole honorable company, you have gathered today at home ?! To do this, you should look at www.cocktail-book.ru (http://www.cocktail-book.ru/). Here you will find cocktail recipes for every taste and mood, each of which you can easily cook yourself! </p>
